Luvata’s Modu-Coil (modular coil) offers a replacement solution for cases where the coil is bigger than the available space to maneuver the coil into its operation location. The Modu-Coil is a fluid coil built in two modules or sections allowing each module to fit in elevators and tight spaces making the transportation and installation of the coil easier. The greatest benefit from the modular coil is that it eliminates the need to demolish walls that otherwise will be needed, resulting in huge savings on expensive demolition/remodel and crane services while reducing down time.
Each of the two modular sections is constructed with one tube plate where each section’s open tubes terminate. At the site, the two sections and one gasket are aligned together using as pilot pins the factory preinstalled bolts in the one section and then fastened together to complete the coil assembly. The modular coil is selected with the same number of rows, fins per inch, tubes high and circuiting as a standard fluid coil. The difference will be on the finned length. Because of the split, the finned length will be effectively reduced by two times the tube plate thickness (minimum 0.75 inches)), too small a length reduction to have any significant impact on the overall coil performance.
0.035" Tube Wall Thickness
0.625" (5/8") Diameter Tube
Additional tube material is not available for the Modu-Coil.
Additional fin material available upon request.
Maximum Pressure of 100 PSIG
Maximum Temperature of 200°F
Request Consultation if Operating Outside of these Ranges
111 Second Ave. NE, Suite 308
St. Petersburg, FL 33701
Rex Sparks: ext. 1 firstname.lastname@example.org
Tom Sparks: ext. 2 tom@southern comfortcoil.com
John Fitzgerald: ext. 3 email@example.com
Your Luvata/Heatcraft Representatives for Custom Coils, Coil Coating and Air Cooled Condensers